How to buy a cone crusher

 

　How to buy cone crusher?

cone crusher is a new concept of fragmentation, the design of a new crusher, machine equipment structural principle of jaw crusher, hammer crusher counterattack crusher Other crusher is different. Broken and produced other types of crushers can not be compared.

　　The cone crusher points Symons cone crusher (Cone Crusher) and hydraulic cone crusher.Above the crushing medium hardness ores and rocks.

　　The cone crusher sub-standard, short head type is generally used in fine crushing.

　　Standard, generally used for the second break, that is broken.

　　The short head type is generally used for thin broken, that is, the final break.

　　 cone crusher have four cavity. Extra coarse, coarse, medium, fine type.

　　How to buy a cone crusher, we give you the most sincere advice.

　　The selection of the principle is the feed size and its exclusive material grain size of the decision, the entry Liaoduo coarse product size, choose special rough or coarse type, and vice versa with medium and fine type. In the calculation of the feed size, the open side of the feed inlet size multiplied by 0.85 to select the size of the feed, while the average size of the product divided by the maximum feed crushing ratio.

　　cone crusher standard type used for the open circuit, short head type is used for closed loop. In the choice of liner, the user must generally consider three factors: yield, power consumption, liner wear; general accordance with the following principles: maximum feed size; changes in particle size, feed particle size distribution; the hardness of the material; the wear resistance of materials. Lining the more the higher the power consumption, hard material to choose a short liner, soft materials selected long-lining, to choose a short liner in the distribution of materials, fine materials, crude materials selected long-lining. Feed particle size distribution, in general, less than the closed edge of the material discharge opening must not exceed 10%, more than 10%, power consumption is increased, the product particle size becomes sheet. Amount of viscous material moisture increase can affect the throughput of materials, the moisture of the material, generally not more than 5%. The use of power: the standard cone crusher should reach 75% to 80%, short head cone crusher should reach 80% ~ 85%. The cone crusher in order to ensure the use of the environment is harsh, dust, combined with some use of unit maintenance is not in place, often a variety of problems in the operation, in general, the cone crusher should note the following problems in the operation,machine run. The cone crusher at work, should be uniform feeding, not segregation. Feeding inequality appears to reduce production capacity, product size is too large, frequent spring action, the bowl bearing pressure, rising power. Have a device in addition to iron, to prevent the crushing chamber is too iron, if frequent iron, it may be caused by a broken shaft accident.

　　Cone crusher above must pay attention to in time to buy, to buy such equipment to invest a lot of money, so we must pay attention when choosing to look at several products, and then choose to buy, as well as is the time of purchase must go to a regular manufacturers to purchase equipment to prevent fooled.